Antler machine embroidry design

Antler machine embroidry design

This design comes with 19  sizes:

2.99”  x 1.79” 2178 st

3.99”  x 2.39” 3101 st

4.49”  x 2.68” 3661 st

4.99”  x 2.98” 4238 st

5.49”  x 3.28” 4868 st

5.99”  x 3.58” 5531 st

6.49”  x 3.88” 6247 st

6.99”  x 4.19” 6991 st

7.49”  x 5.19” 8808 st

7.99”  x 5.54” 9745 st

8.49”  x 5.88” 10811 st

8.99”  x  6.23” 11853 st

9.49”  x 6.58” 13021 st

 9.99”  x 6.92”  14057 st

10.49”  x 8.05” 16742 st

10.99”  x 8.43” 18218 st

11.49”  x 8.81” 19622 st

11.99”  x 9.19” 21091 st

 The following 8 formats are included in the file you will receive:

* DST – (Tajima)

* EXP – (Melco)

* HUS – (Husqvarna,Viking)

* JEF – (Janome,Elna,Kenmore)

* PES – (Brother,Deco,Babylock)

* SEW – (Janome,Elna,Kenmore)

* VP3 – (Pfaff. Husqvarna,Viking)

* XXX – (Compucon, Singer)

 

Please note this is NOT a patch or a physical item. This is an embroidery design. You will need an embroidery machine to stitch these designs out.

**************************************************************************************************

You MUST have an embroidery machine and the software needed to transfer it from your computer to the machine to use this file. This listing is for the machine file only – not a finished item.

************************************************************************************

For a quality stitched design, I recommend using proper stabilizer and needle size for the project fabric along with quality thread. In particular, with fine gauge and knit fabric, such as T-shirts and baby onsies, I find it best to use a sticky back stabilizer on the fabric with a stitch and tear stabilizer on top of it inside the fabric AND a wash away stabilizer on the outside of the fabric, especially when stitching fonts or thin lines. A thinner gauge knit needle can prevent needle holes as well.